Users Guide
I am not able to access the iDRAC page through the
host OS after performing an iDRAC factory reset
operation, such as racadm racresetcfg. How do I
troubleshoot the issue?
Ensure that the OS to iDRAC passthru channel is enabled. By default, it is disabled in factory mode. To enable the OS to IDRAC passthru
channel on iDRAC, use the following command, racadm set idrac.os-bmc.adminstate 1.
I am seeing the past Life Cycle Logs (LCL) alerts
targeted for SNMP traps replicated in Operating
System logs. Can I troubleshoot the issue?
iSM will not be able to distinguish between the past Life Cycle Log (LCL) alerts targeted for SNMP traps and past LCL alerts targeted for
OS Logs. Hence user may see past LCL alerts targeted for OS Logs in SNMP traps as well and vice versa.
I am seeing 169.254.0.2 as the source IP address in
the iDRAC SNMP trap received via iSM. How do I
troubleshoot the issue?
On Linux OS, the iDRAC SNMP traps received via Host OS displays the hostname or source IP address as 169.254.0.2 instead of the actual
Host OS name or IP address. This is decided by the OS to populate the entry before rendering the trap to the user.
I have congured OS to iDRAC pass-through to LOM
and when I try to run dcism-sync, the update
operation fails. What can be done?
OS to iDRAC pass-through should be congured to USB-NIC mode. This is a pre-requisite for iDRAC Service Module installation and
update.
Frequently asked questions
47