Install Guide
Table Of Contents
- iDRAC Service Module 2.4 Installation Guide
- Contents
- Introduction
- New in this release
- iDRAC Service Module monitoring features
- Operating system information
- Lifecycle Controller log replication into operating system
- Automatic system recovery feature
- Windows Management Instrumentation Providers
- Automatic Technical Support Report collection
- Prepare to remove NVMe PCIe SSD device
- Remote iDRAC hard reset
- iDRAC access via Host OS (Experimental Feature)
- In-band support for iDRAC SNMP alerts
- Supported features — operating systems matrix
- Co-existence of Server Administrator and iDRAC Service Module
- Software availability
- Downloading iDRAC Service Module
- Accessing documents from the Dell EMC support site
- Software license agreement
- Other documents you may need
- Preinstallation setup
- Installing the iDRAC Service Module on Microsoft Windows operating systems
- Installing the iDRAC Service Module on Microsoft Windows operating systems
- Modifying the iDRAC Service Module components on Microsoft Windows operating systems
- Repairing the iDRAC Service Module on Microsoft Windows operating systems
- Uninstalling the iDRAC Service Module on Microsoft Windows operating systems
- Installing iDRAC Service Module on supported Linux operating system
- Installing the iDRAC Service Module on VMware ESXi
- Installing the iDRAC Service Module on Citrix XenServer
- Configuring the iDRAC Service Module
- Frequently asked questions
- Linux installer packages
Configuring the iDRAC Service Module
You can configure the iDRAC Service Module using the:
● iDRAC web interface
● RACADM CLI command
● WSMAN command
Topics:
• Configuring The iDRAC Service Module From iDRAC Web Interface
• Configuring the iDRAC Service Module from RACADM
• Configuring the iDRAC Service Module from WSMAN
Configuring The iDRAC Service Module From iDRAC
Web Interface
To use the iDRAC Service Module from the iDRAC Web interface, go to Overview > Server > Service Module.
Configuring the iDRAC Service Module from RACADM
The iDRAC Service Module can be accessed and configured through RACADM CLI commands. To know the status of the
features provided by the iDRAC Service Module, use racadm get idrac.servicemodule command. This command lists
the features and their status of the iDRAC Service Module:
● OSInfo
● LCLReplication
● WMI Information
● Auto System Recovery Action
● iDRAC access via Host OS
● iDRACHardReset
To set or configure the features, use racadm set idrac.servicemodule. <feature name> <enabled or
disabled>.
7
Configuring the iDRAC Service Module 25