Install Guide

Enable WSMAN Remotely
Currently with the WMI information feature, you can connect to the host Microsoft Windows WMI namespace to monitor the
system hardware. The WMI interface on the host is enabled by default and you can access it remotely. However, if you wish to
access the WMI interfaces using WINRM’s WMI adapter, you have to enable it manually as it is not enabled by default. Using
this feature, you can access the WINRM WMI namespaces remotely by enabling it during installation.
This feature can be accessed using PowerShell commands. The commands used are as follows:
Table 1.
Command Description
Enable-iSMWSMANRemote —Status enable —
Forcereconfigure yes —Createselfsigncert yes —
IPAddress <IP address> —Authmode Basic, Kerberos,
Certificate
Enabling and configuring the remote WSMAN feature
Enable-iSMWSMANRemote —Status get
Viewing the status of remote WSMAN feature
Enable-iSMWSMANRemote —Status disable
Disable remote WSMAN feature
Enable-iSMWSMANRemote —Status enable —
Forcereconfigure yes —Createselfsigncert yes —
IPAddress <IP address>
Reconfigure the remote WSMAN feature
NOTE: You must have a server authenticating certificate and a https protocol to work with this feature.
Supported features — operating systems matrix
The following is the list of supported features and the operating system.
Table 2. Supported features — operating systems matrix
Generation Features Operating Systems
Microsoft
Windows
(including
HyperV systems)
Linux Virtualization
(VMware ESXi)
Citrix XenServer
12th generation
and 13th
generation
Sharing OS
Information
Yes Yes Yes Yes
12th generation
and 13th
generation
LC Log Replication Yes Yes Yes Yes
12th generation
and 13th
generation
Automatic
System Recovery/
Watchdog
Yes Yes Yes Yes
13th generation
Windows
Management
Instrumentation
Providers
Yes No No Yes
13th generation
Prepare to Remove
NVMe device
through iDRAC
Yes Yes Yes* Yes
13th generation
SupportAssist
Collection
Yes Yes No Yes
8 Introduction