Release Notes

• On Linux Operating Systems, when iDRAC Service Module 2.3.0 and iDRAC Service Module 2.3.0.1 patch are installed, then to
uninstall iDRAC Service Module completely, the iDRAC Service Module 2.3.0.1 patch has to be uninstalled before uninstalling iDRAC
Service Module 2.3.0.
• The iDRAC Access via Host OS feature is not supported on VMware ESXi Operating Systems.
• When Local RACADM set is disabled through iDRAC interfaces,
• The iDRAC Service Module will fail to configure the OS to iDRAC Pass-through in the USB NIC mode.
• If OS to iDRAC Pass-through in the USB NIC mode is already configured, Watchdog feature does not work resulting in ASR000
event.
iDRAC Service Module functionality is restored when "Local racadm set" is enabled.
• When you use iDRAC Service Module 2.3 for WMI queries over winrm, additional properties with null value is observed. This does not
affect the functionality and it can be ignored.
• If iDRAC Service Module 2.3.0 is installed on a Linux OS with the iDRAC Access via Host OS feature enabled, you have to to remove
the rules of the previous port when upgrading from 2.3.0 to 2.4.0.
• When the iDRAC's USB NIC is not functioning, the iDrac Service Module installer is completing the installation and starting the iDRAC
Service Module process without any notification about the failure to start the communication with the iDRAC. This issue is observed
during iDRAC Service Module is installed using setup.sh command the iDRAC.
4 iDRAC Service Module 2.4 Release Notes