Administrator Guide
Input Parameter Description
LogicalNetworkName The name of the VMM logical network that will be used for tenant networks.
If not specied, the default name of Tenant VLANs will be used.
Name An optional name that is used to generate the IP address pool name and VM Network name.
If not specied, the default name Tenant will be used.
The resulting VM Network and IP address pool names would be Tenant – VLAN
#
, where # is the VLAN ID
specied for the network.
PoolEnd The ending address for the IP address pool.
Optional if Subnet is specied.
If not specied, the last address in the Subnet will be used.
Example: 192.168.0.254
PoolStart The starting address for the IP address pool.
Optional if Subnet is specied.
Example: 192.168.0.1
Subnet The IP subnet for the network, in the format IP_Address/Prex.
If not specied, DHCP will be used.
Example: 1192.168.0.0/24
UplinkPortProleName The exact name of the Uplink Port Prole that was created during deployment.
If not specied, the default name UplinkPortProle is used.
VlanId The VLAN ID to assign to the network.
Conguring VLANs for tenant use
For tenants to use and access network resources, you need to create VM networks in VMM. These VM networks must map to VLANs that
exist in the physical network. Therefore, you must rst congure VLANs on your physical network switches, based on management,
application, or tenant requirements for isolation.
Ensure that each added VLAN is available on the trunk for all ports on which the Hyper-V hosts in the Dell Hybrid Cloud System for
Microsoft stamp are connected. Note that this does not include the backup server.
Also, congure your routers so that the VLANs are routable to users who will need to connect to VMs on the stamp.
Follow the instructions from the hardware manufacturer of your network switch and router.
Adding tenant VM networks to the cloud
After you create the tenant VM networks, you must add them to the Tenant Cloud in VMM.
1 In the VMM console, open the VMs and Services workspace.
2 Under Clouds, right-click Tenant Cloud, and then click Properties.
3 Click the Logical Networks tab.
Administration
27