Administrator Guide
NOTE: If this is not the rst time the server has been reset, you might receive an error message saying:
REAGENTC.EXE: Windows RE is disabled. In that case, open an elevated Windows PowerShell session, and run the
following commands:
• Stop-Service clussvc
• reagentc /enable
• If you receive a message saying REAGENTC.EXE: Operations successful, type reagentc /boottore.
5
Restart the server. From the Open Command windows type Shutdown –r –t 0.
6 When the server restarts in the Windows Recovery Environment, click Troubleshoot.
Figure 78. Windows Recovery Environment menu
7 On the Troubleshoot menu, click Advanced options.
Figure 79. Troubleshoot advanced
8 In Advanced options, click Command Prompt.
Appendix B: Performing a factory reset
149