Administrator Guide

Save cloud files for offline use
Cloud files can be manually saved for offline use, where a user can use the file when network is not available. If you manually set
the file to offline mode, you must log off and log in again and then discard the offline file to synchronize the file to cloud.
Prerequisites
Ensure that you have configured the cloud provider—Azure or Google Cloud.
About this task
This procedure describes the steps to manually save a cloud file offline on Dell Hybrid Client.
Steps
1. Log in to the Dell Hybrid Client.
2. Go to File Explorer > CLOUD FILES.
All the available cloud files or documents are listed.
3. Locate a file and click the three vertical dots that is located in the same row.
4. Click Save Offline.
The file is saved offline, and a green tick is displayed for the Offline status.
Next steps
To change offline files to online manually, do the following:
1. Locate the offline file.
2. Click the three vertical dots that is located in the same row.
3. Click Discard Offline File.
Configure a network drive
A network drive is a drive or share that you can access over a network. Dell Hybrid Client enables you to mount or map a
network shared drives using network file sharing protocols. The supported protocols are Server Message Block (SMB), Common
Internet File System (CIFS), FTPS, and Samba Share.
Steps
1. Log in to Wyse Management Suite.
2. Go to the Groups & Configs page, and select your preferred group.
3. Click Edit Policies > Hybrid Client.
The Configuration Control | Hybrid Client page is displayed.
4. Click the Advanced tab.
5. Expand Network Drives, and click Network Drivers List.
6. Click Add Row.
7. In the Network drives settings section, do the following:
a. In the Name field, enter a name for your network drive or share.
b. From the Type drop-down list, select the type of the network share—Smb/Samba, CIFS, or FTPS.
8. In the Share URL field, enter the address of the server in the form of URL.
● If you are using the network share type as SMB/Samba or CIFS, enter the share URL in the format //serverIP/
path. For example, //105.105.55.122/test.
● If you are using the network share type as FTPS, enter the share URL in the format serverIP. For example,
105.105.55.122.
9. If you want anonymous users to access the network share, click the Anonymous mode toggle key.
10. If you want specific users to access the network share, disable the Anonymous mode, and do the following:
a. Enter the username.
b. Enter the password.
78
User applications