Deployment Guide
Table Of Contents
- Dell Hybrid Client Version 1.x Conversion and Upgrade Guide
- Introduction
- Supported platforms for Dell Hybrid Client conversion
- Dell Hybrid Client 1.0 or 1.1 to Dell Hybrid Client 1.5 upgrade
- Convert Dell Wyse 5070 devices to Dell Hybrid Client
- Convert Dell Generic Client to Dell Hybrid Client
- Upgrade from Dell Hybrid Client version 1.0 to 1.1
- Dell OptiPlex and Latitude conversions
- Frequently asked questions
- Contacting Dell
Dell Hybrid Client 1.0 or 1.1 to Dell Hybrid
Client 1.5 upgrade
Prerequisites
● Download the Dell Hybrid Client 1.5 - Image upgrade addon package from the Drivers and Downloads section of the
Dell Hybrid Client product page or the respective hardware product pages at www.dell.com/support.
● Download the ISO image corresponding to your platform model:
○ Dell Hybrid Client 1.5 - ISO Conversion Image for Wyse 5070
○ Dell Hybrid Client 1.5 - ISO Conversion Image for 7070 Optiplex Ultra
● Extract the ISO file from the downloaded zip file.
Steps
1. Go to Groups & Configs and click the device group, DHC-DEV-GRP, where the Dell Hybrid Client 1.0 or 1.1 devices are
registered.
You can rename the device group.
2. Create two device subgroups. For example, DhcUpgradeStageNotify and DhcUpgradeStageUpgrade inside the device
group, DHC-DEV-GRP.
You can rename both the device subgroups.
Figure 1. Device sub-groups
3. Copy the image upgrade add-on DHCImageUpgradeAddon.tar.gz and image upgrade iso file
DellHybridClient_1.5_750_5070.iso or DellHybridClient_1.5_750_7070.iso corresponding to the platform model to
the Wyse Management Suite local repository—<RepoPath>\repository\hybridClientApps>. For example, C:
\WMSRepo3\repository\hybridClientApps.
3
Dell Hybrid Client 1.0 or 1.1 to Dell Hybrid Client 1.5 upgrade 7