Users Guide

Exit the Dell HBA355i HII configuration utility
About this task
To exit the HII configuration utility (Ctrl+C), perform the following steps:
Steps
1. Press Esc on any menu screen.
If there is only one controller, then a dialog box is displayed to confirm your choice.
2. Select OK to exit and press Enter.
If multiple controllers are present, then the Esc key brings you to the Controller Selection screen.
3. Press Esc again to reach the exit screen.
A dialog box is displayed to confirm your choice.
4. Select OK to exit and press Enter.
Navigating to the Dell HBA355i configuration utility
Steps
1. Enter the HII configuration utility. See Enter the Dell HBA355i HII configuration utility on page 20.
The Device Settings screen displays a list of NIC ports and the Dell HBA355i front configuration utility.
2. To access the Dell HBA355i front configuration utility, click Dell HBA355i Front Configuration Utility.
The following list of configuration options is displayed:
● Controller Properties
● Refresh Topology
● Device Properties
Controller management
Controller management allows you to configure, manage, and view the controller properties.
Viewing the controller properties
The View Controller Properties screen allows you to view the controller properties.
About this task
In the System Setup Main Menu, click Device Settings > Dell HBA355i Front Configuration Utility > Controller
Management > View Controller Properties.
The table explains the View Controller Properties screen details:
Table 4. View Controller Properties options
Option Description
Controller name Controller name
Chip name Controller chip name
PCI revision ID Controller PCI revision ID
PCI Bus:Dev:Func PCI Bus: Device: Controller function format
PCI Ven: Dev Controller PCI Vendor ID and Device ID
PCI SSVen:SSDev Controller PCI Sub Vendor ID and Sub Device ID
Manage Dell HBA355i card using HII configuration utility 21