Users Guide

Steps

1. Turn off the system, including any attached peripherals, and disconnect the system from the electrical outlet.

NOTE: It is recommended that you always use a static mat and static strap while working on components in the interior

of the system.

2. Open the system.

3. Connect the SAS data cable connectors to the card.

NOTE: Ensure that you connect the cable according to the connector labels on the cable. The cable does not function

properly if reversed.

4. Align the card-edge connector with the connector on the system board.

CAUTION: To prevent damage to the card, hold the card by its edges only.

5. Press the card-edge down until the card is fully seated in the connector

6. Close the system.

7. Reconnect the system to its electrical outlet and turn the system on, including any attached peripherals.

Figure 6. Install the Dell HBA355i front card

Next steps

1. Follow the procedure listed in After working inside your system on page 10.

Install and remove a Dell HBA355i card