Users Guide
Table Of Contents
- Dell Technologies Host Bus Adapter User's Guide HBA355i and HBA355e
- Dell HBA355i and Dell HBA355e
- Dell HBA355i
- Dell HBA355i front card
- Dell HBA355e
- Dell HBA355i and Dell HBA355e technical specifications
- PowerEdge systems supported by Dell HBA355i
- PowerEdge systems supported by Dell HBA355e
- Operating systems supported by Dell HBA355i and Dell HBA355e
- MD1400 and MD1420 enclosure support for Dell HBA355e
- Port support matrix for dual path on the same MD1400 and MD1420 enclosure
- ME484 enclosure support for Dell HBA355e
- Port support matrix for dual path on the same ME484 enclosure
- Tape drive support for Dell HBA355e
- Applications supported by Dell HBA355i and Dell HBA355e
- Dell HBA355e enclosure support
- Features of Dell HBA355i and Dell HBA355e
- Installation and removal of cards
- Safety instructions
- Before working inside your system
- After working inside your system
- Remove the Dell HBA355i adapter
- Install the Dell HBA355i adapter
- Remove the Dell HBA355i front card
- Install the Dell HBA355i front card
- Remove the Dell HBA355e adapter
- Install the Dell HBA355e adapter
- Connect Dell HBA355e to the storage enclosure
- Driver support Dell HBA355i and Dell HBA355e
- Manage Dell HBA355i and Dell HBA355e cards using HII configuration utility
- Updating the firmware of Dell HBA355i and Dell HBA355e
- Getting help
- Troubleshooting
- Known issues
- VendorID and ProductID for tape drives
- System reserved partition after Windows installation
- Device settings in HII shows PCIe slot information
- Intermittent RSODs appears when a faulty drive is connected to HBA
- Selecting drive for operating system installation in legacy mode
- Adapter configuration change message
- Incompatible firmware image when incorrect payload is used
- Additional disks displayed in the command line interface
- Known issues
- Documentation resources
Table 7. Device at Slot 0 Logical Enclosure 1 properties
Option Description
Vendor name Vendor name of the drive
Product name Product name of the drive
Revision name Revision version of the drive
Serial number Serial of the physical disk
Capacity Capacity of the drive
Logical/Physical sector size Sector size of the selected physical disk
Multipath device Drive supports multipath or not
SAS address SAS address of the physical disk
Negotiated logical link rate Negotiated logical link rate of the device
Negotiated physical link rate Negotiated physical link rate of the device
Maximum drive rate Maximum possible drive rate
Write cache You can either enable or disable the Write Cache
Locate LED You can either select On or Off the locate LED
Legacy OpROM boot device You can either select Yes or No
3. Click Apply Changes to submit the changes selected.
A confirmation screen is displayed. Click Ok to continue.
4. To choose another device click Next Device in this Enclosure.
Manage Dell HBA355i and Dell HBA355e cards using HII configuration utility
33