White Papers

4 Dell EMC OEM Identity Module | Installation Guide using GUI
1 Introduction
The Dell EMC OEM Identity Module enables OEMs to rebrand and customize their products. The Identity
module centralizes the control points of multiple features, enabling OEM customers to save time and
resources when deploying their systems.
You can install the OEM Identity Module using the following:
 Dell Remote Access Controller Admin utility
 RACADM — Remote RACADM or Local RACADM
 iDRAC web interface
This document describes the process of installing an OEM Identity Module on a Dell EMC enterprise system
using the iDRAC web interface.
The target audience for this document is OEM customers and partners of Dell EMC who are looking for a
graphical method of installing an Identity Module.
For installing the module using a command-line interface85520, see Dell EMC OEM Identity Module
Installation Guide using RACADM Command Line Interface.
Note: The Dell EMC OEM Identity Module is also referred to as Personality Module in some earlier
documentation.
2 Prerequisites
 iDRAC version 1.30.30 or later.
 A system with a supported OS and browser to access the iDRAC web interface.
 CSIOR must be enabled. For more information, see Lifecycle Controller User’s Guide.
 CustBSU.pm file — Use this file while performing the steps mentioned in this document. In some
cases, you may have a [PartNumber]_CustBSU_ver.exe file. To access the CustBSU.pm file
located in this self-extracting package, extract the contents of this file and locate the CustBSU.pm file.
Note: Do not use an IDM that does not have BSU in the file name.