Reference Guide

186 Lifecycle Controller Web Services Interface Guide for Linux
16.24 Convert Physical Disk Drives to Non RAIDConvertToNonRAID()
The ConvertToNonRAID() method is used to convert a physical disk drives in RAID state of “Ready” to a
Non-RAID state. After the method is successfully ran, the PendingValue property of RAIDPDState should
reflect the pending changes. After the CreateTargetedConfigJob method is successfully ran, the
RAIDStatus property, which is enumerated in the DCIM_PhysicalDiskView from Section 16.9, of that
physical disk drive should reflect the new state.
Invoke ConvertToNonRAID() with the following parameters and syntax:
Physical Disk TARGET: Obtained from the FQDD field (Section 16.9)
An example of Disk.Bay.2:Enclosure.Internal.0-0:RAID.Slot.1-1 is shown below.
EXAMPLE:
wsman invoke ConvertToRAID "cimv2/root/dcim/DCIM_RAIDService?
SystemCreationClassName=DCIM_ComputerSystem +CreationClassName=DCIM_RAIDServic
e+SystemName=DCIM:ComputerSystem+Name=DCIM:RAIDService"
-h $IPADDRESS -V -v -c dummy.cert -P 443
-u $USERNAME -p $PASSWORD
-J СonvertToRAID.xml -j utf-8 -y basic
OUTPUT:
ConvertToNonRAID_OUTPUT
RebootRequired = 1
ReturnValue = 0