Reference Guide

ManualsBrandsDell ManualsConverged InfrastructureGeneral Solution Resources

181

182

183

184

185

186

187

188

189

190

184 Lifecycle Controller Web Services Interface Guide for Linux

16.22.3 Changing the Value of a RAID Controller Integer Attribute

The SetAttribute() method is used to set or change the value of a RAID controller integer attribute. The

example below shows setting an controller attribute.

Invoke the SetAttribute() method with the following parameters (from Section 16.1) and syntax:

TARGET: Obtained from the FQDD field

AttributeName: Obtained from the AttributeName field

AttributeValue: Obtained from the PossibleValues field

EXAMPLE:

wsman invoke -a SetAttribute

http://schemas.dmtf.org/wbem/wscim/1/cimschema/2/root/dcim/DCIM_RAIDService?

SystemCreationClassName=DCIM_ComputerSystem,CreationClassName=DCIM_RAIDService

,SystemName=DCIM:ComputerSystem,Name=DCIM:RAIDService

-h $IPADDRESS -V -v -c dummy.cert -P 443

-u $USERNAME -p $PASSWORD

-J SetAttribute_Integer_RAID_Controller.xml -j utf-8 -y basic

The input file SetAttribute_Integer_RAID_Controller.xml is shown below:

<p:SetAttribute_INPUT

xmlns:p="http://schemas.dmtf.org/wbem/wscim/1/cimschema/2/root/dcim/DCIM_RAIDS

ervice">

<p:Target>RAID.Integrated.1-1</p:Target>

<p:AttributeName>RAIDccRate</p:AttributeName>

<p:AttributeValue>60</p:AttributeValue>

</p:SetAttribute_INPUT>

OUTPUT:

<n1:SetAttribute_OUTPUT>

<n1:Message>The method was successful.</n1:Message>

<n1:MessageID>STOR001</n1:MessageID>

<n1:RebootRequired>Yes</n1:RebootRequired>

<n1:ReturnValue>0</n1:ReturnValue>

<n1:SetResult>Set Pending Value</n1:SetResult>

</n1:SetAttribute_OUTPUT>

16.22.4 Changing Multiple Values of RAID Controller Integer Attributes

The SetAttributes() method is used to set or change multiple values of RAID controller attributes.

The following example shows setting multiple RAID controller integer attributes.

Invoke SetAttributes with the following parameters (from Section 16.1) and syntax: