Reference Guide

498 | Open Shortest Path First (OSPFv2 and OSPFv3)
www.dell.com | support.dell.com
OSPF functions and features, such as MD5 Authentication, Grace Period, Authentication Wait Time, etc,
are assigned on a per interface basis.
Figure 24-9 presents an example of assigning an IP address to an interface and then assigning an OSPFv2
area that includes that Layer-3 interface’s IP address.
Figure 24-9. Configuring an OSPF Area Example
Dell Networking recommends that the OSPFv2 Router ID be the interface IP addresses for easier
management and troubleshooting.
Use the
show config command in CONFIGURATION ROUTER OSPF mode to view the configuration.
OSPF, by default, sends hello packets out to all physical interfaces assigned an IP address that are a subset
of a network on which OSPF is enabled. Use the
show ip ospf interface command (Figure 410) to view
the interfaces currently active and the areas assigned to the interfaces.
Figure 24-10. Command Example: show ip ospf process-id interface
Note: If using features like MD5 Authentication, ensure all the neighboring routers are
also configured for MD5.
FTOS#(conf)#int gi 4/44
FTOS(conf-if-gi-4/44)#ip address 10.10.10.10/24
FTOS(conf-if-gi-4/44)#no shutdown
FTOS(conf-if-gi-4/44)#ex
FTOS(conf)#router ospf 1
FTOS(conf-router_ospf-1)#network 1.2.3.4/24 area 0
FTOS(conf-router_ospf-1)#network 10.10.10.10/24 area 1
FTOS(conf-router_ospf-1)#network 20.20.20.20/24 area 2
FTOS(conf-router_ospf-1)#
FTOS#
Assign Layer-3 interface
with IP Address and
no shutdown
Assign interface’s
IP Address to an Area
FTOS>show ip ospf 1 interface
GigabitEthernet 12/17 is up, line protocol is up
Internet Address 10.2.2.1/24, Area 0.0.0.0
Process ID 1, Router ID 11.1.2.1, Network Type BROADCAST, Cost: 1
Transmit Delay is 1 sec, State DR, Priority 1
Designated Router (ID) 11.1.2.1, Interface address 10.2.2.1
Backup Designated Router (ID) 0.0.0.0, Interface address 0.0.0.0
Timer intervals configured, Hello 10, Dead 40, Wait 40, Retransmit 5
Hello due in 00:00:04
Neighbor Count is 0, Adjacent neighbor count is 0
GigabitEthernet 12/21 is up, line protocol is up
Internet Address 10.2.3.1/24, Area 0.0.0.0
Process ID 1, Router ID 11.1.2.1, Network Type BROADCAST, Cost: 1
Transmit Delay is 1 sec, State BDR, Priority 1
Designated Router (ID) 13.1.1.1, Interface address 10.2.3.2
Backup Designated Router (ID) 11.1.2.1, Interface address 10.2.3.1
Timer intervals configured, Hello 10, Dead 40, Wait 40, Retransmit 5
Hello due in 00:00:05
Neighbor Count is 1, Adjacent neighbor count is 1
Adjacent with neighbor 13.1.1.1 (Designated Router)
FTOS>