Command Line Reference Guide

684 | Multicast
www.dell.com | support.dell.com
Command Modes
EXEC
EXEC Privilege
Command
History
Example
Figure 24-6. Command Example: show ipv6 mroute
Example
Figure 24-7. Command Example: show ipv6 mroute active
active [rate]
(OPTIONAL) Enter the keyword active to view active multicast
sources. Enter a rate to view active routes over the specified rate.
Range: 0 to 10000000 packets/second
count
group-address [ source
source-address]}
(OPTIONAL) Enter the keyword count to view the number of IPv6
multicast routes and packets on the E-Series. Optionally, enter the IPv6
source-address count information.
Version 7.4.1.0 Introduced
YForce10#show ipv6 mroute
IP Multicast Routing Table
(165:87:32::30, ff05:100::1), uptime 00:01:11
Incoming interface: Vlan 200
Outgoing interface list:
GigabitEthernet 2/14
(165:87:37::30, ff05:200::1), uptime 00:01:04
Incoming interface: Port-channel 200
Outgoing interface list:
Vlan 200
(165:87:31::30, ff05:300::1), uptime 00:01:19
Incoming interface: GigabitEthernet 2/14
Outgoing interface list:
Port-channel 200
(165:87:32::30, ff05:1100::1), uptime 00:01:08
Incoming interface: Vlan 200
Outgoing interface list:
GigabitEthernet 2/14
(165:87:37::30, ff05:2200::1), uptime 00:01:01
Incoming interface: Port-channel 200
Outgoing interface list:
Vlan 200
Force10#
Force10#show ipv6 mroute active 10
Active Multicast Sources - sending >= 10 pps
Group: ff05:300::1
Source: 165:87:31::30
Rate: 100 pps
Group: ff05:3300::1
Source: 165:87:31::30
Rate: 100 pps
Group: ff3e:300::4000:1
Source: 165:87:31::20
Rate: 100 pps
Group: ff3e:3300::4000:1
Source: 165:87:31::20
Rate: 100 pps
Force10#