Command Line Reference Guide

682 | Multicast
www.dell.com | support.dell.com
Command Modes
EXEC
EXEC Privilege
Command
History
Example
Figure 24-5. Command Example: show queue backplane multicast
Related
Commands
IPv6 Multicast Commands
IPv6 Multicast commands are:
• clear ipv6 mroute
• ipv6 multicast-limit
• ipv6 multicast-routing
•
• show ipv6 mroute
• show ipv6 mroute mld
• show ipv6 mroute summary
clear ipv6 mroute
e
Clear learned multicast routes on the multicast forwarding table. To clear the PIM tib, use clear ip pim
tib command.
Syntax
clear ipv6 mroute {group-address [source-address] | *}
Parameters
Defaults
No default behavior or values
Command Modes
EXEC Privilege
Command
History
Version 7.7.1.0 Introduced on E-Series
Force10#show queue backplane multicast bandwidth-percent
Configured multicast bandwidth percentage is 80
queue backplane
multicast
Reallocate the amount of bandwidth dedicated to multicast traffic.
group-address
[
source-address]
Enter multicast group address and source address (if desired) to clear information
on a specific group. Enter the addresses in the
x:x:x:x::x format.
The :: notation specifies successive hexadecimal fields of zero.
* Enter * to clear all multicast routes.
Version 7.4.1.0 Introduced