Command Line Reference Guide

680 | Multicast
www.dell.com | support.dell.com
Parameters
Command Modes
EXEC
EXEC Privilege
Command
History
Example 1
Figure 24-2. Command Example: show ip mroute static
Example 2
Figure 24-3. Command Example: show ip mroute
static (OPTIONAL) Enter the keyword static to view static multicast routes.
group-address
[source-address]
(OPTIONAL) Enter the multicast group-address to view only routes associated
with that group.
Enter the source-address to view routes with that group-address and
source-address.
active [rate] (OPTIONAL) Enter the keyword active to view only active multicast routes.
Enter a rate to view active routes over the specified rate.
Range: 0 to 10000000
count (OPTIONAL) Enter the keyword count to view the number of multicast routes
and packets on the E-Series.
summary (OPTIONAL) Enter the keyword summary to view routes in a tabular format.
Version 8.3.3.1 Introduced on S60
Version 7.6.1.0 Introduced on S-Series
Version 7.5.1.0 Introduced on C-Series
E-Series legacy command
Force10#show ip mroute static
Mroute: 23.23.23.0/24, interface: Lo 2
Protocol: static, distance: 0, route-map: none, last change: 00:00:23
Force10#
Force10#show ip mroute
IP Multicast Routing Table
(*, 224.10.10.1), uptime 00:05:12
Incoming interface: GigabitEthernet 3/12
Outgoing interface list:
GigabitEthernet 3/13
(1.13.1.100, 224.10.10.1), uptime 00:04:03
Incoming interface: GigabitEthernet 3/4
Outgoing interface list:
GigabitEthernet 3/12
GigabitEthernet 3/13
(*, 224.20.20.1), uptime 00:05:12
Incoming interface: GigabitEthernet 3/12
Outgoing interface list:
GigabitEthernet 3/4
Force10#