Command Line Reference Guide

632 | Layer 2
www.dell.com | support.dell.com
Usage
Information
To return VLAN 1 as the Default VLAN, use this command syntax (default-vlan-id 1).
The Default VLAN contains only untagged interfaces.
Related
Commands
default-vlan disable
c e s
Disable the default VLAN so that all switchports are placed in the Null VLAN until they are explicitly
configured as a member of another VLAN.
Defaults
The default VLAN is enabled.
Command Modes
CONFIGURATION
Command
History
Usage
Information
no default vlan disable is not listed in the running-configuration, but when the default VLAN is
disabled, default-vlan disable is listed in the running-configuration.
enable vlan-counters
e
x
Display VLAN counters for ingress and/or egress hardware. You must be in restricted mode to use this
command.
Syntax
enable vlan-output-counters [ingress | egress | all]
To return to the default (disabled), use the no enable vlan-output-counters command.
Defaults
Disabled—VLAN counters are disabled in hardware (all linecards/port-pipes) by default.
Command Modes
CONFIGURATION
Command
History
interface vlan Configure a VLAN.
Version 8.3.3.1 Introduced on the S60.
Version 8.3.1.0 Introduced
Version 8.1.1.2 Introduced on E-Series ExaScale E600i
Version 8.1.1.0 Introduced on E-Series ExaScale E1200i