Command Line Reference Guide

630 | Layer 2
www.dell.com | support.dell.com
Command
History
Example
E-Series output:
Force10#show mac learning-limit
Interface Vlan Learning Dynamic Static Unknown SA
Slot/port Id Limit MAC count MAC count Drops
Gi 5/84 2 2 0 0 0
Gi 5/84 * 5 0 0 0
Gi 5/85 3 3 0 0 0
Gi 5/85 * 10 0 0 0
Force10#show mac learning-limit interface gig 5/84
Interface Vlan Learning Dynamic Static Unknown SA
Slot/port Id Limit MAC count MAC count Drops
Gi 5/84 2 2 0 0 0
Gi 5/84 * 5 0 0 0
Force10#show mac learning-limit interface gig 5/84 vlan 2
Interface Vlan Learning Dynamic Static Unknown SA
Slot/port Id Limit MAC count MAC count Drops
Gi 5/84 2 2 0 0 0
Example
C-Series/S-Series output:
Force10#show mac learning-limit
Interface Learning Dynamic Static Unknown SA
Slot/port Limit MAC count MAC count Drops
Gi 1/0 10 0 0 0
Gi 1/1 5 0 0 0
Force10#show mac learning-limit interface gig 1/0
Interface Learning Dynamic Static Unknown SA
Slot/port Limit MAC count MAC count Drops
Gi 1/0 10 0 0 0
Virtual LAN (VLAN) Commands
The following commands configure and monitor Virtual LANs (VLANs). VLANs are a virtual
interface and use many of the same commands as physical interfaces.
You can configure an IP address and Layer 3 protocols on a VLAN called Inter-VLAN routing. FTP,
TFTP, ACLs and SNMP are not supported on a VLAN.
Occasionally, while sending broadcast traffic over multiple Layer 3 VLANs, the VRRP state of a
VLAN interface may continually switch between Master and Backup.
• description
• default vlan-id
• default-vlan disable
• enable vlan-counters
• name
• show config
• show vlan
• tagged
• track ip
• untagged
Version 8.3.1.0
Added
vlan option on E-Series.
Version 7.7.1.0 Introduced on C-Series
Version 7.5.1.0
Added support for
violate-action and detail options
Version 6.5.1.0 Added support for Port Channel