Command Line Reference Guide

IPv6 Basics | 585

IPv6 Basics

Overview

IPv6 Basic Commands are supported on platforms c e and s as designated by the symbols

beneath the commands

E-Series ExaScale supports IPv6 with FTOS 8.2.1.0 and later.

Commands

The IPv6 commands in the chapter are:

• clear ipv6 fib

• clear ipv6 route

• ipv6 address

• ipv6 unicast-routing

• show ipv6 cam linecard

• show ipv6 cam stack-unit

• show ipv6 fib linecard

• show ipv6 fib stack-unit

• show ipv6 interface

• show ipv6 route

• trust ipv6-diffserv

clear ipv6 fib

c e s

Clear (refresh) all FIB entries on a line card.

Syntax

clear ipv6 fib linecard slot

Parameters

Command Mode

EXEC Privilege

Note: The IPv6 basic commands are supported on all platforms. However, not all features are

supported on all platforms. See the table in Chapter 17, IPv6 Addressing to determine the

FTOS version that supports which features and platforms.

slot

Enter the slot number to clear the FIB for a line card.