Command Line Reference Guide

580 | IPv6 Access Control Lists (IPv6 ACLs)
www.dell.com | support.dell.com
IPv6 Route Map Commands
The following commands allow you to configure route maps and their redistribution criteria.
• match ipv6 address
• match ipv6 next-hop
• match ipv6 route-source
• route-map
• set ipv6 next-hop
• show config
• show route-map
match ipv6 address
c e
Configure a filter to match routes based on IPv6 addresses specified in an access list.
Syntax
match ipv6 address prefix-list-name
To delete a match, use the no match ipv6 address prefix-list-name command.
Parameters
Defaults
Not configured.
Command Modes
ROUTE-MAP
Command
History
Table 17-3. Output Explanations: test cam-usage
Term Explanation
Linecard
Lists the line card or line cards that are checked. Entering
all shows
the status for line cards in the chassis
Portpipe Lists the portpipe (port-set) or port pipes (port-sets) that are checked.
Entering all shows the status for line cards and port-pipes in the
chassis.
CAM Partition Shows the CAM profile of the CAM
Available CAM Identifies the amount of CAM space remaining for that profile
Estimated CAM per Port Estimates the amount of CAM space the listed policy will require.
Status Indicates whether or not the policy will be allowed in the CAM
prefix-list-name
Enter the name of IPv6 prefix list, up to 140 characters.
Version 8.2.1.0 Introduced support on the E-Series ExaScale
Version 7.8.1.0 Introduced support on the C-Series
Increased name string to accept up to 140 characters. Prior to 7.8.1.0, names are up to 16
characters long.
Version 7.4.1.0 Introduced support on the E-Series