Command Line Reference Guide

ManualsBrandsDell ManualsserversDell Force10 S60-44T

571

572

573

574

575

576

577

578

579

580

IPv6 Access Control Lists (IPv6 ACLs) | 579

Parameters

Defaults

None

Command Modes

EXEC Privilege

Command

History

Usage

Information

This command applies to both IPv4 and IPv6 CAM Profiles, but is best used when verifying QoS

optimization for IPv6 ACLs.

QoS Optimization for IPv6 ACLs does not impact the CAM usage for applying a policy on a single (or

the first of several) interfaces. It is most useful when a policy is applied across multiple interfaces; it

can reduce the impact to CAM usage across subsequent interfaces.

Example

The following example shows the output shown when using the test cam-usage command.

Figure 17-8. Command Example: test cam-usage (C-Series)

policy-map name

Enter the name of the policy-map to verify.

number Enter all to get information for all the linecards, or enter the linecard number to get

information for a specific card.

Range: 0-6 for E-Series, 0-7 for C-Series

Version 8.2.1.0 Introduced support on the E-Series ExaScale

Version 7.8.1.0 Introduced on C-Series and E-Series

Force10#test cam-usage service-policy input LauraMapTest linecard all

------------------------------------------------------------------------------------------

2 | 1 | IPv4Flow | 232 | 0 | Allowed

2 | 1 | IPv6Flow | 0 | 0 | Allowed

4 | 0 | IPv4Flow | 232 | 0 | Allowed

4 | 0 | IPv6Flow | 0 | 0 | Allowed

Force10#

Force10#test cam-usage service-policy input LauraMapTest linecard 4 port-set 0

------------------------------------------------------------------------------------------

4 | 0 | IPv4Flow | 232 | 0 | Allowed

4 | 0 | IPv6Flow | 0 | 0 | Allowed

Force10#

Force100#test cam-usage service-policy input LauraMapTest linecard 2 port-set 1

------------------------------------------------------------------------------------------

2 | 1 | IPv4Flow | 232 | 0 | Allowed

2 | 1 | IPv6Flow | 0 | 0 | Allowed

Force10#