Command Line Reference Guide

550 | IPv4 Routing
www.dell.com | support.dell.com
Usage
Information
The F10 Monitoring MIB provides access to the statistics described below.
show protocol-termination-table
e
Display the IP Packet Termination Table (IPPTT).
Syntax
show protocol-termination-table linecard number port-set port-pipe-number
Parameters
Defaults
No default behavior or values
...short packets The number of bytes in the packet are too small.
...bad length The length of the packet was not correct.
...no port broadcasts The incoming broadcast/multicast packet did not have any listener.
...socket full The applications buffer was full and the incoming packet had to be dropped.
Table 16-16. show ip traffic output definitions
Keyword Definition
Table 16-17. F10 Monitoring MIB
Command Display Object OIDs
IP statistics:
Bcast:
Received
Sent
f10BcastPktRecv
f10BcastPktSent
1.3.6.1.4.1.6027.3.3.5.1.1
1.3.6.1.4.1.6027.3.3.5.1.2
Mcast:
Received
Sent
f10McastPktRecv
f10McastPktSent
1.3.6.1.4.1.6027.3.3.5.1.3
1.3.6.1.4.1.6027.3.3.5.1.4
ARP statistics:
Rcvd:
Request
Replies
f10ArpReqRecv
f10ArpReplyRecv
1.3.6.1.4.1.6027.3.3.5.2.1
1.3.6.1.4.1.6027.3.3.5.2.3
Sent:
Request
Replies
Proxy
f10ArpReqSent
f10ArpReplySent
f10ArpProxySent
1.3.6.1.4.1.6027.3.3.5.2.2
1.3.6.1.4.1.6027.3.3.5.2.4
1.3.6.1.4.1.6027.3.3.5.2.5
linecard number Enter the keyword linecard followed by slot number of the line card.
E-Series Range: 0 to 13 on a E1200/1200i, 0 to 6 on a E600/E600i,
and 0 to 5 on a E300
port-set port-pipe-number Enter the keyword port-set followed by the line card’s Port-Pipe
number.
Range: 0 to 1