Command Line Reference Guide

492 | Interfaces
www.dell.com | support.dell.com
wanport
e
Enable the WAN mode on a TenGigabitEthernet interface.
Syntax
wanport
To disable the WAN Port, enter no wanport.
Defaults
Not configured.
Command Modes
CONFIGURATION
Command
History
Usage
Information
The port must be in a shutdown state to change from LAN mode to WAN mode and vice-versa as
shown in the figure below.
For E-Series ExaScale systems, you must configure all the ports in a port-pipe to either WANPHY or
non-WANPHY. They cannot be mixed on the same port-pipe.
Example
Figure 15-41. wanport Command with shutdown Command Example
Related
Commands
The following related commands are valid for E-Series only.
Version 8.1.1.2 Introduced on E-Series ExaScale
pre-Version 6.2.1.0 Introduced for E-Series
interface TenGigabitEthernet 13/0
no ip address
no shutdown
Force10(conf-if-te-13/0)#
Force10(conf-if-te-13/0)#wanport
% Error: Port should be in shutdown mode, config ignored Te 13/0.
Force10(conf-if-te-13/0)#
Force10(conf-if-te-13/0)#shutdown
Force10(conf-if-te-13/0)#
Force10(conf-if-te-13/0)#wanport
Force10(conf-if-te-13/0)#
ais-shut Send LAIS on shutdown
alarm-report Enable reporting of a selected alarm
clock source Configure a clock source
down-when-looped Send a message when a loopback condition is detected
flag Set flags to ensure interoperability
framing Set framing type
keepalive Enable keepalive
loopback Troubleshoot a SONET loopback