Command Line Reference Guide

490 | Interfaces
www.dell.com | support.dell.com
speed (Management interface)
c e
Set the speed for the Management interface.
Syntax
speed {10 | 100 | auto}
To return to the default setting, use the no speed {10 | 100} command.
Parameters
Defaults
auto
Command Modes
INTERFACE
Command
History
Usage
Information
This command is found on the Management interface only.
Related
Commands
stack-unit module
s
Pre-configure ports on 10G optical modules in optional slots to preserve configuration.
Syntax
stack-unit {stack-unit id} module {module id}
Parameters
Defaults
None
Command Modes
Configuration
Command
History
10 Enter the keyword 10 to set the interface’s speed to 10 Mb/s.
100 Enter the keyword 100 to set the interface’s speed to 100 Mb/s.
auto Enter the keyword auto to set the interface to auto-negotiate its speed.
Version 8.1.1.0 Introduced on E-Series ExaScale
Version 7.5.1.0 Introduced on C-Series
pre-Version 6.2.1.0 Introduced for E-Series
interface ManagementEthernet Configure the Management port on the system (either the Primary or
Standby RPM).
duplex (Management) Set the mode of the Management interface.
management route Configure a static route that points to the Management interface or a
forwarding router.
stack-unit id
Enter the unit number of the stacked unit.
Range: 0 - 11
module id
Enter the module id number of the optional slot.
Range: 0 - 1
Version 8.3.3.7 Introduced on S-Series S60