Command Line Reference Guide

Interfaces | 483
Related
Commands
show interfaces transceiver
ces
Display the physical status and operational status of an installed transceiver. The output also displays
the transceiver’s serial number.
Syntax
show interfaces [gigabitethernet | tengigabitethernet] slot/port transceiver
Parameters
Command Modes
EXEC
EXEC Privilege
Command
History
Usage
See the figure below for an example screenshot, and see the following table or a description of the
output fields.
For related commands, see the Related Commands section, below, and see the Debugging and
Diagnostics chapter for your platform at the end of this book.
interface Configure a physical interface on the switch.
show ip interface Displays Layer 3 information about the interfaces.
show interfaces Display information on a specific physical interface or virtual interface.
show interfaces transceiver Display the physical status and operational status of an installed transceiver.
The output also displays the transceiver’s serial number.
gigabitethernet For a 10/100/1000 interface, enter the keyword gigabitethernet followed by
the slot/port information.
tengigabitethernet For a 10G interface, enter the keyword tengigabitethernet followed by the
slot/port information.
Version 8.3.3.1 Introduced on the S60.
Version 8.1.1.0 Introduced on E-Series ExaScale
Version 7.8.1.0 Output augmented with diagnostic data for pluggable media
Version 7.7.1.0 Removed three fields in output: Vendor Name, Vendor OUI, Vendor PN
Version 7.6.1.0 Introduced on C-Series and S-Series
Version 6.5.4.0 Introduced on E-Series