Command Line Reference Guide

Interfaces | 481
Command
History
Example
Figure 15-37. show interfaces status Command Example
Related
Commands
show interfaces switchport
c e s
Display only virtual and physical interfaces in Layer 2 mode. This command displays the Layer 2
mode interfaces’ IEEE 802.1Q tag status and VLAN membership.
Syntax
show interfaces switchport [interface [linecard slot-number] | stack-unit unit-id ]
Parameters
Version 8.3.3.1 Introduced on the S60.
Version 8.1.1.0 Introduced on E-Series ExaScale
Version 7.6.1.0 Introduced on S-Series
Version 7.5.1.0 Introduced on C-Series
Version 7.5.1.0 Introduced on E-Series
Force10#show interfaces status
Port Description Status Speed Duplex Vlan
Gi 0/0 Up 1000 Mbit Auto --
Gi 0/1 Down Auto Auto 1
Gi 0/2 Down Auto Auto 1
Gi 0/3 Down Auto Auto --
Gi 0/4 Force10Port Up 1000 Mbit Auto 30-130
Gi 0/5 Down Auto Auto --
Gi 0/6 Down Auto Auto --
Gi 0/7 Up 1000 Mbit Auto 1502,1504,1506-1508,1602
Gi 0/8 Down Auto Auto --
Gi 0/9 Down Auto Auto --
Gi 0/10 Down Auto Auto --
Gi 0/11 Down Auto Auto --
Gi 0/12 Down Auto Auto --
Gi 0/13 Down Auto Auto --
Gi 0/14 Down Auto Auto --
Gi 0/15 Down Auto Auto --
Force10#
show interfaces Display information on a specific physical interface or virtual interface.
interface
Enter one of the following keywords and slot/port or number information:
• For a 1-Gigabit Ethernet interface, enter the keyword
GigabitEthernet followed
by the slot/port information.
• For a port channel interface, enter the keyword
port-channel followed by a
number:
C-Series and S-Series Range: 1-128
E-Series Range: 1 to 255 for TeraScale and ExaScale
• For SONET interfaces, enter the keyword
sonet followed by the slot/port
information. This keyword is only available on E-Series and C-Series.
• For a 10-Gigabit Ethernet interface, enter the keyword
TenGigabitEthernet
followed by the slot/port information.
• Enter the keyword
backup to view the backup interface for this interface.