Command Line Reference Guide

Interfaces | 447
• On the C-Series and S-Series systems, the flow-control sender and receiver must be on the same
port-pipe. Flow control is not supported across different port-pipes on the C-Series or S-Series
system.
Example
Figure 15-4. show running config (partial)
The table below displays how FTOS negotiates the flow control values between two Dell Force10
chassis connected back-to-back using 1G copper ports.
Related
Commands
Force10(conf-if-gi-0/1)#show config
!
interface GigabitEthernet 0/1
no ip address
switchport
no negotiation auto
flowcontrol rx off tx on
no shutdown
...
Table 15-1. Negotiated Flow Control Values
Configured Negotiated
LocRxConf LocTxConf RemoteRxConf RemoteTxConf LocNegRx LocNegTx RemNegRx RemNegTx
off off off
off
on
on
off
on
off
on
off
off
off
off
off
off
off
off
off
off
off
off
off
off
off
off
off on off
off
on
on
off
on
off
on
off
off
off
off
off
off
on
off
off
off
on
off
off
off
off
off
on off off
off
on
on
off
on
off
on
off
on
on
on
off
off
on
on
off
off
on
on
off
on
on
on
on on off
off
on
on
off
on
off
on
off
off
on
on
off
off
on
on
off
off
on
on
off
off
on
on
show running-config Display the flow configuration parameters (non-default values only).
show interfaces Display the negotiated flow control parameters.