Manualshelf

Command Line Reference Guide

ManualsBrandsDell ManualsserversDell Force10 S60-44T
371372373374375376377378379380
Content Addressable Memory (CAM) | 377
Command Modes
CONFIGURATION
Command
History
Usage
Information
You must save the new CAM settings to the startup-config (write-mem or copy run start) then
reload the system for the new settings to take effect.
The total amount of space allowed is 16 FP Blocks. System flow requires 3 blocks and these cannot be
reallocated.
When configuring space for IPv6 ACLs, the total number of Blocks must equal 13.
Ranges for the CAM profiles are 1-10, except for the ipv6acl profile which is 0-10. The ipv6acl
allocation must be a factor of 2 (2, 4, 6, 8, 10).
cam-acl-egress
Allocate CAM for egress ACLs
Syntax
cam-acl-egress default | l2acl
Parameters
Command Modes
CONFIGURATION
Command
History
Version 8.3.3.1 Introduced on the S60.
Version 8.3.1.0
Added
ecfmacl, vman-qos, and vman-dual-qos keywords.
Version 8.2.1.0 Introduced on the S-Series
Version 7.8.1.0 Introduced on the C-Series
default
Reset egress CAM ACL entries to default settings.
l2acl
number
Allocate space for Layer 2 egress ACL.
Range: 1-4 FP blocks
Version 8.3.3.4 Introduced on the S60.