Command Line Reference Guide

Control and Monitoring | 151
virtual-ip
c e
Configure a virtual IP for the active management interface.
Syntax
virtual-ip ip address
To return to the default, use the no virtual-ip ip address command.
Parameters
Defaults
No default behavior or values
Command Modes
CONFIGURATION
Command
History
Related
Commands
write
c e s
Copy the current configuration to either the startup-configuration file or the terminal.
Syntax
write {memory | terminal}
Parameters
Command Modes
EXEC Privilege
Command
History
Related
Commands
Usage
Information
The write memory command saves the running-configuration to the file labeled
startup-configuration. When using a LOCAL CONFIG FILE other than the startup-config not named
“startup-configuration” (for example, you used a specific file during the boot config command) the
running-config is not saved to that file; use the copy command to save any running-configuration
changes to that local file.
ip address
Enter the IP address of the active management interface in a dotted decimal format
(A.B.C.D.)
Version 8.1.1.0 Introduced on E-Series ExaScale
Version 7.5.1.0 Introduced on C-Series
E-Series original Command
ip address Assign a primary and secondary IP address to the interface.
memory Enter the keyword memory to copy the current running configuration to the startup
configuration file. This command is similar to the
copy running-config
startup-config
command.
terminal Enter the keyword terminal to copy the current running configuration to the terminal. This
command is similar to the
show running-config command.
Version 8.3.3.1 Introduced on the S60.
Version 8.1.1.0 Introduced on E-Series ExaScale
Version 7.6.1.0 Introduced on S-Series
Version 7.5.1.0 Introduced on C-Series
E-Series original Command
save
Save configurations created in uBoot.