Command Line Reference Guide

150 | Control and Monitoring
www.dell.com | support.dell.com
util-threshold mem (S-Series)
s
Configure the high or low memory utilization thresholds for SNMP traps.
Syntax
util-threshold mem {Management-unit | standby | stack-unit unit-number | all} {high {0-100} | {low
[0-100}}}
To return to the default setting, enter the no util-threshold mem command syntax.
Parameters
Defaults
High threshold default = 92%
Low threshold default = 82%
Command Modes
CONFIG
Command
History
Usage
Information
When the total memory utilization exceeds the configured threshold for a given time, a threshold
notification is sent as a SNMP trap. If a low threshold value is not specified, the low threshold value is
set to the same value as the high threshold value.
unit
Indicate the unit where you want to configure the memory utilization thresholds.
• Management-unit
• standby
• stack-unit unit-number = select the number of the unit in the stack
• all = use all of the units to configure the memory utilization information.
utilization
threshold in %
Indicate the high or low values for the memory utilization in percentage format.
• high. Range: 0 - 100
• low. Range: 0 - 100
Note: A threshold level of0 will disable the syslog and SNMP trap.
Version 8.3.3.8 Introduced on S60.
Version 8.3.5.3 Introduced on S55.
Version 8.4.2.2 Introduced on C-Series, S25 and S50
Version 8.4.2.0 Introduced on E-Series TeraScale
Version 8.4.1.0 Introduced on E-Series ExaScale