Command Line Reference Guide

Control and Monitoring | 143
Command
History
Usage
Information
Opening a telnet connection from the Standby RPM to an Active RPM follows the authentication
procedure configured in the chassis. However, opening a telnet connection from the Active RPM into
the Standby RPM requires local authentication.
Configuring an ACL on a VTY line will block a Telnet session using the telnet-peer-rpm command
in the standby to active RPM direction only. Such an ACL will not block an internal Telnet session in
the active RPM to standby RPM direction.
telnet-peer-stack-unit
Open a Telnet connection to the peer stack unit.
Syntax
telnet-peer-stack-unit
Defaults
Not configured.
Command Modes
EXEC
EXEC Privilege
Command
History
terminal length
c e s
Configure the number of lines displayed on the terminal screen.
Syntax
terminal length screen-length
To return to the default values, enter terminal no length.
Parameters
Defaults
24 lines
Command Modes
EXEC
EXEC Privilege
Command
History
Version 8.1.1.0 Introduced on E-Series ExaScale
Version 7.5.1.0 Introduced on C-Series
Version 6.2.1.1 Introduced on E-Series
Version 8.3.3.4 Introduced on S60
screen-length
Enter a number of lines. Entering zero will cause the terminal to display without
pausing.
Range: 0 to 512.
Default: 24 lines.
Version 8.3.3.1 Introduced on the S60.
Version 8.1.1.0 Introduced on E-Series ExaScale
Version 7.6.1.0 Introduced on S-Series