Command Line Reference Guide

142 | Control and Monitoring
www.dell.com | support.dell.com
Defaults
Not configured.
Command Modes
EXEC
EXEC Privilege
Command
History
telnet-peer-rpm
c e
Open a Telnet connection to the peer RPM.
Syntax
telnet-peer-rpm
Defaults
Not configured.
Command Modes
EXEC
EXEC Privilege
vrf instance
(Optional) E-Series Only: Enter the keyword vrf followed by the VRF Instance
name.
source-interface (OPTIONAL) Enter the keywords /source-interface followed by the interface
information to include the interface’s IP address.
Enter the following keywords and slot/port or number information:
• For a 100/1000 Ethernet interface, enter the keyword GigabitEthernet
followed by the slot/port information.
• For a 1-Gigabit Ethernet interface, enter the keyword
GigabitEthernet
followed by the slot/port information.
• For a Loopback interface, enter the keyword
loopback followed by a
number from zero (0) to 16383.
• For the Null interface, enter the keyword
null followed by 0.
• For a Port Channel interface, enter the keyword
port-channel followed by a
number:
C-Series and S-Series Range: 1-128
E-Series Range: 1 to 255 for TeraScale
• For SONET interface types, enter the keyword
sonet followed by the slot/
port information.
• For a 10-Gigabit Ethernet interface, enter the keyword
TenGigabitEthernet followed by the slot/port information.
• For a VLAN interface, enter the keyword
vlan followed by a number from 1
to 4094.
Version 8.3.3.1 Introduced on the S60.
Version 8.2.1.0 Introduced on E-Series ExaScale (IPv6)
Increased number of VLANs on ExaScale to 4094 (was 2094)
Version 8.1.1.0 Introduced on E-Series ExaScale (IPv4)
Version 7.9.1.0 Introduced VRF.
Version 7.6.1.0 Introduced on S-Series
Version 7.5.1.0 Introduced on C-Series and added support for IPv6 address on E-Series only