Command Line Reference Guide

1004 | S-Series Stacking Commands
www.dell.com | support.dell.com
Command Modes
EXEC Privilege
Command
History
Usage
Information
You can renumber any switch, including the management unit or a stand-alone unit.
You cannot renumber a unit to a number of an active member in the stack.
When executing this command on the master, the stack reloads. When the members are renumbered,
only that specific unit will reset and come up with the new unit number.
Example
Figure 40-6. stack-unit renumber Command Example
Related
Commands
upgrade system stack-unit (S-Series stack member)
s
Copy the boot image or FTOS from the management unit to one or more stack members.
Syntax
upgrade {boot | system} stack-unit {all | stack-unit}
Parameters
Defaults
No configuration or default values
Command Modes
EXEC
Command
History
Version 8.3.3.4 Introduced on S60
Version 7.7.1.0 Introduced on S-Series
S50V_7.7#stack-unit 0 renumber 2
Renumbering master unit will reload the stack. Proceed to renumber [confirm yes/
no]:
reload Reboot FTOS.
reset stack-unit Reset the designated S-Series stack member.
show system (S-Series) Display the current status of all stack members or a specific member.
boot
Enter this keyword to copy the boot image from the management unit to the
designated stack members.
system
Enter this keyword to copy the FTOS image from the management unit to the
designated stack members.
all
Enter this keyword to copy the designated image to all stack members.
stack-unit
Enter the stack member unit identifier of the stack member to reset.
S60 range: 0 - 11
all other S-Series range: 0-7
Version 8.3.3.4 Introduced on S60
Version 7.7.1.0 Introduced on S-Series