Command Line Reference Guide

S-Series Stacking Commands | 1003
Command Modes
CONFIGURATION
Command
History
Related
Commands
stack-unit provision
s
Pre-configure a logical stacking ID of a switch that will join the stack. This is an optional command
that is executed on the management unit.
Syntax
stack-unit stack-unit provision {S25N|S25P|S25V|S50N|S50V |S60}
Parameters
Defaults
When this value is not set, a switch joining the stack is given the next available sequential stack
member identifier.
Command Modes
CONFIGURATION
Command
History
Related
Commands
stack-unit renumber
s
Change the stack member ID of any stack member or a stand-alone S-Series.
Syntax
stack-unit stack-unit renumber stack-unit
Parameters
Defaults
none
Version 8.3.3.4 Introduced on S60
Version 7.7.1.0 Introduced on S-Series
reload Reboot FTOS.
show system (S-Series) Display the current status of all stack members or a specific member.
stack-unit
Enter the stack member unit identifier of the stack member to reset.
S60 range: 0 - 11
all other S-Series range: 0-7
S25N|S25P|S25V||
S50N|S50V|S60
Enter the S-Series model identifier of the switch to be added as a stack member. This
identifier is also referred to as the provision type.
Version 8.3.3.4 Introduced on S60
Version 7.7.1.0 Introduced on S-Series
reload Reboot FTOS.
show system (S-Series) Display the current status of all stack members or a specific member.
stack-unit
Enter the stack member unit identifier of the stack member to reset.
S60 range: 0 - 11
all other S-Series range: 0-7
The first instance of this value is the stack member unit identifier, from 0 to 7, of the
switch that you want add to the stack.
The second instance of this value is the desired new unit identifier number.