Command Line Reference Guide

1000 | S-Series Stacking Commands
www.dell.com | support.dell.com
Related
Commands
show redundancy
s
Display the current redundancy configuration (status of automatic reboot configuration on stack
management unit).
Syntax
show redundancy
Command Modes
EXEC
EXEC Privilege
Command
History
Example
Figure 40-2. show redundancy Command Output
reload Reboot FTOS.
upgrade (S-Series management unit) Reset the designated S-Series stack member.
Version 8.3.3.4 Introduced on S60
Version 7.7.1.0 Introduced on S-Series
Force110#show redundancy
Force10#show redundancy
-- SSeries Redundancy Configuration --
------------------------------------------------
Auto reboot : Enabled
-- Stack-unit Status --
------------------------------------------------
Mgmt ID: 0
Stack-unit ID: 0
Stack-unit Redundancy Role: Primary
Stack-unit State: Active
Stack-unit SW Version: 7.7.1.0
Link to Peer: Up
-- PEER Stack-unit Status --
------------------------------------------------
Stack-unit State: Standby
Peer stack-unit ID: 1
Stack-unit SW Version: 7.7.1.0
-- Stack-unit Redundancy Configuration --
------------------------------------------------
Primary Stack-unit: mgmt-id 0
Auto Data Sync: Full
Failover Type: Hot Failover
Auto reboot Stack-unit: Enabled
Auto failover limit: 3 times in 60 minutes
-- Stack-unit Failover Record --
------------------------------------------------
Failover Count: 0
Last failover timestamp: None
Last failover Reason: None
Last failover type: None
-- Last Data Block Sync Record: --
------------------------------------------------
Line Card Config: succeeded Mar 07 1996 00:27:39
Start-up Config: succeeded Mar 07 1996 00:27:39
Runtime Event Log: succeeded Mar 07 1996 00:27:39
Running Config: succeeded Mar 07 1996 00:27:39
ACL Mgr: succeeded Mar 07 1996 00:27:39