Reference Guide

86 | Control and Monitoring
www.dell.com | support.dell.com
Parameters
Defaults
The IP address on the system that is closest to the Telnet address is used in the outgoing packets.
Command Modes
CONFIGURATION
Command
History
Related
Commands
ip tftp blksize
Configure the TFTP block size.
Syntax
ip tftp blksize blocksize
Parameters
Defaults
512
Command Modes
CONFIGURATION
Command
History
Usage
Information
Ensure your TFTP server supports file transfers over 32 MB in size. Recent TFTP servers will support
the larger file size, but TFTP servers running older TFTP protocol will not.
interface
Enter the following keywords and slot/port or number information:
• For an 100/1000 Ethernet interface, enter the keyword
GigabitEthernet followed by the
slot/port information.
• For a 1-Gigabit Ethernet interface, enter the keyword
GigabitEthernet followed by the
slot/port information.
• For Loopback interfaces, enter the keyword
loopback followed by a number from zero
(0) to 16383.
• For the SONET interfaces, enter the keyword
sonet followed by slot/port information.
• For a Port Channel, enter the keyword
port-channel followed by a number:
C-Series and S-Series: 1-128
E-Series: 1 to 255 for TeraScale and ExaScale
• For a 10-Gigabit Ethernet interface, enter the keyword
TenGigabitEthernet followed
by the slot/port information.
• For VLAN interface, enter the keyword
vlan followed by a number from 1 to 4094.
Version 8.3.5.0 Introduced on the S55.
Version 8.2.1.0 Increased number of VLANs on ExaScale to 4094 (was 2094)
Version 8.1.1.0 Introduced on E-Series ExaScale
Version 7.6.1.0 Support added for S-Series
Version 7.5.1.0 Introduced on C-Series
E-Series original Command
telnet Telnet to another device.
block-size
Enter the number of bytes to allocate for the TFTP block size.
Default: 512.
Range is from 512 to 8192.
Version 8.3.3.9 Introduced on the S60.
Version 8.3.5.5 Introduced on the S55.