Reference Guide

72 | Control and Monitoring
www.dell.com | support.dell.com
Related
Commands
cam-audit linecard
e
Enable audit of the IPv4 forwarding table on all line cards.
Syntax
cam-audit linecard all ipv4-fib interval time-in-minutes
To disable audit, use the no cam-audit linecard all ipv4-fib command
Parameters
Defaults
Disabled
Command Modes
CONFIGURATION
Command
History
Usage
Information
Enables periodic audits of software and hardware copies of the IPv4 forwarding table.
clear alarms
c e s
Clear alarms on the system.
Syntax
clear alarms
Command Modes
EXEC Privilege
Command
History
Usage
Information
This command clear alarms that are no longer active. If an alarm situation is still active, it is seen in the
system output.
banner exec Sets a banner to be displayed when you enter the EXEC Privilege mode.
banner login Sets a banner to be displayed after successful login to the system.
all Enter the keyword all to enable CAM audit on all line cards.
ipv4-fib Enter the keyword ipv4-fib to designate the CAM audit on the IPv4
forwarding entries.
interval time-in-minutes Enter the keyword interval followed by the frequency in minutes of the
CAM audit.
Range: 5 to 1440 minutes (24 hours)
Default: 60 minutes
Version 7.4.1.0 Introduced on E-Series
Version 8.3.5.0 Introduced on the S55.
Version 8.1.1.0 Introduced on E-Series ExaScale
Version 7.6.1.0 Introduced on S-Series
Version 7.5.1.0 Introduced on C-Series
E-Series original Command