Reference Guide

iSCSI Optimization | 605
Command
History
Usage
Information
• LLDP must be enabled before using this command.
• LLDP cannot be disabled if iSCSI is enabled.
iscsi priority-bits
Configure the priority bitmap to be advertised in iSCSI application TLVs.
Syntax
iscsi priority-bits
To remove the configured priority bitmap, use the no iscsi priority-bits command.
Defaults
4 (0x10 in the bitmap)
Command Modes
PROTOCOL LLDP (only on global, not on interface)
Command
History
iscsi profile-compellent
Configure the auto-detection of Compellent arrays on a port.
Syntax
iscsi profile-compellent
Defaults
Compellent disk arrays are not detected.
Command Modes
INTERFACE
Command
History
Version 8.3.3.8 Introduced on the S60
Version 8.3.12.0 Introduced on the S4810.
Version 8.3.16.0 Introduced on MXL 10/40GbE Switch IO Module
Version 8.3.12.0 Introduced on the S4810.
Version 8.3.16.0 Introduced on MXL 10/40GbE Switch IO Module
Version 8.3.5.3 Introduced on the S55
Version 8.3.3.8 Introduced on the S60
Version 8.3.12.0 Introduced on the S4810.
Version 8.3.16.0 Introduced on MXL 10/40GbE Switch IO Module