Reference Guide

550 | IPv4 Routing
www.dell.com | support.dell.com
show ip management-route
c e
View the IP addresses assigned to the Management interface.
Syntax
show ip management-route [all | connected | summary | static]
Parameters
Command Modes
EXEC
EXEC Privilege
Command
History
Example
Figure 15-18. show ip management route Command Example
show ip protocols
c e s
View information on all routing protocols enabled and active on the switch.
Syntax
show ip protocols
Command Modes
EXEC
EXEC Privilege
Command
History
all (OPTIONAL) Enter the keyword all to view all IP addresses assigned to all
Management interfaces on the switch.
connected (OPTIONAL) Enter the keyword connected to view only routes directly
connected to the Management interface.
summary (OPTIONAL) Enter the keyword summary to view a table listing the number
of active and non-active routes and their sources.
static (OPTIONAL) Enter the keyword static to view non-active routes also.
Version 8.3.5.0 Introduced on S55.
Version 8.3.3.1 Introduced on S60.
Version 8.1.1.0 Introduced on E-Series ExaScale
Version 7.5.1.0 Introduced on C-Series
pre-Version 6.1.1.0 Introduced for E-Series
FTOS#show ip management-route
Destination Gateway State
----------- ------- -----
10.1.2.0/24 ManagementEthernet 0/0 Connected
172.16.1.0/24 10.1.2.4 Active
FTOS#
Version 8.3.5.0 Introduced on the S55.
Version 8.1.1.0 Introduced on E-Series ExaScale
Version 7.6.1.0 Regular evaluation optimization enabled/disabled added to display output
Version 7.6.1.0 Introduced on S-Series