Reference Guide

IPv4 Routing | 549
Figure 15-17. show ip interface brief Command Example (Partial)
Table 15-12. show ip interface Command Example Items
Lines Description
TenGigabitEthernet 0/0... Displays the interface’s type, slot/port and physical and line protocol
status.
Internet address... States whether an IP address is assigned to the interface. If one is, that
address is displayed.
IP MTU is... Displays IP MTU value.
Inbound access... Displays the name of the any configured incoming access list. If none is
configured, the phrase “not set” is displayed.
Proxy ARP... States whether proxy ARP is enabled on the interface.
Split horizon... States whether split horizon for RIP is enabled on the interface.
Poison Reverse... States whether poison for RIP is enabled on the interface
ICMP redirects... States if ICMP redirects are sent.
ICMP unreachables... States if ICMP unreachable messages are sent.
Table 15-13. show ip interface brief Column Headings
Field Description
Interface Displays type of interface and the associated slot and port number.
IP-Address Displays the IP address for the interface, if configured.
Ok? Indicates if the hardware is functioning properly.
Method
Displays
Manual if the configuration is read from the saved configuration.
Status
States whether the interface is enabled (up) or disabled (administratively
down
).
Protocol
States whether IP is enabled (up) or disabled (down) on the interface.
FTOS#show ip int brief
Interface IP-Address OK? Method Status Protocol
GigabitEthernet 1/0 unassigned NO Manual administratively down down
GigabitEthernet 1/1 unassigned NO Manual administratively down down
GigabitEthernet 1/2 unassigned YES Manual up up
GigabitEthernet 1/3 unassigned YES Manual up up
GigabitEthernet 1/4 unassigned YES Manual up up
GigabitEthernet 1/5 10.10.10.1 YES Manual up up
GigabitEthernet 1/6 unassigned NO Manual administratively down down