Reference Guide
548 | IPv4 Routing
www.dell.com | support.dell.com
Parameter
Command Modes
EXEC
EXEC Privilege
Command
History
Example
Figure 15-16. show ip interface Command Example
interface
(OPTIONAL) Enter the following keywords and slot/port or number information:
• For a 1-Gigabit Ethernet interface, enter the keyword
GigabitEthernet followed
by the slot/port information.
• For a Loopback interface, enter the keyword
Loopback followed by a number
from 0 to 16383.
• For the Management interface, enter the keyword
ManagementEthernet
followed by zero (0).
• For the Null interface, enter the keyword
null followed by zero (0).
• For a Port Channel interface, enter the keyword
port-channel followed by a
number:
C-Series and S-Series Range: 1-128
E-Series Range: 1 to 32 for EtherScale, 1 to 255 for TeraScale.
• For a SONET interface, enter the keyword
sonet followed by the slot/port
information.
• For a 10-Gigabit Ethernet interface, enter the keyword
TenGigabitEthernet
followed by the slot/port information.
• For a VLAN, enter the keyword
vlan followed by a number from 1 to 4094.
brief (OPTIONAL) Enter the keyword brief to view a brief summary of the interfaces and
whether an IP address is assigned.
linecard
slot-number
(OPTIONAL) Enter the keyword linecard followed by the number of the line card
slot.
C-Series Range: 0-7
E-Series Range: 0 to 13 on a E1200/1200i, 0 to 6 on a E600/E600i, and 0 to 5 on a
E300
Note: This keyword is not available on the S-Series.
configuration (OPTIONAL) Enter the keyword configuration to display the physical interfaces
with non-default configurations only.
Version 8.3.5.0 Introduced on the S55.
Version 8.1.1.2 Supported on E-Series ExaScale E600i
Version 8.1.1.0 Introduced on E-Series ExaScale
Version 7.6.1.0 Introduced on S-Series
Version 7.5.1.0 Introduced on C-Series
pre-Version 6.1.1.0 Introduced for E-Series
FTOS#show ip int te 0/0
TenGigabitEthernet 0/0 is down, line protocol is down
Internet address is not set
IP MTU is 1500 bytes
Inbound access list is not set
Proxy ARP is enabled
Split Horizon is enabled
Poison Reverse is disabled
ICMP redirects are not sent
ICMP unreachables are not sent
FTOS#