Reference Guide

IPv4 Routing | 535
Related
Commands
management route
c e
Configure a static route that points to the Management interface or a forwarding router.
Syntax
management route ip-address mask {forwarding-router-address | managementethernet}
To remove a static route, use the no management route ip-address mask
{forwarding-router-address | managementethernet} command.
Parameters
Defaults
Not configured.
Command Modes
CONFIGURATION
Command
History
Usage
Information
When a static route (or a protocol route) overlaps with Management static route, the static route (or a
protocol route) is preferred over the Management Static route. Also, Management static routes and the
Management Connected prefix are not reflected in the hardware routing tables.
Related
Commands
ip-selection packet-based
Packet based: IPV4
No distribution: IPV6
Packet based: IPV4 MAC based
ip-selection packet-based and mac
MAC based Packet based: IPV4 MAC based
Table 15-3. Configurations of the load-balance Command
Configuration Switched IP Traffic
Routed IP Traffic
(IPV4 Only)
Switched Non-IP
Traffic
ip address Change the algorithm used to distribute traffic on an E-Series chassis.
ip-address mask
Enter an IP address (dotted decimal format) and mask (/prefix
format) as the IP address for the Management interface.
forwarding-router-address
Enter an IP address (dotted decimal format) of a forwarding router.
managementethernet Enter the keyword managementethernet for the
Management interface on the Primary RPM.
Version 8.3.5.0 Introduced on S55
Version 8.3.3.1 Introduced on S60.
Version 8.1.1.0 Introduced on E-Series ExaScale
Version 7.5.1.0 Support added for C-Series
pre-Version 6.1.1.0 Introduced for E-Series
interface ManagementEthernet Configure the Management port on the system (either the Primary or
Standby RPM).
duplex (Management) Set the mode of the Management interface.
speed (Management interface) Set the speed for the Management interface.