Reference Guide

46 | File Management
www.dell.com | support.dell.com
Figure 3-7. restore factory-defaults (NvRAM only, all units in a stack) Command
Example
Figure 3-8. restore factory-defaults (NvRAM only, single unit in a stack) Command
Example
show boot system
sc e
Displays information about boot images currently configured on the system.
Syntax
show boot system {all | linecard [slot | all] | rpm | stack-unit [0-11 | all]}
Parameters
FTOS#restore factory-defaults stack-unit all nvram
***********************************************************************
* Warning - Restoring factory defaults will delete the existing *
* persistent settings (stacking, fanout, etc.) *
* All the units in the stack will be split into standalone units. *
* After restoration the unit(s) will be powercycled immediately. *
* Proceed with caution ! *
***********************************************************************
Proceed with factory settings? Confirm [yes/no]:yes
-- Restore status --
Unit Nvram Config
------------------------
0 Success
1 Success
2 Success
3 Not present
4 Not present
5 Not present
Power-cycling the unit(s).
FTOS#
FTOS#restore factory-defaults stack-unit 1nvram
***********************************************************************
* Warning - Restoring factory defaults will delete the existing *
* persistent settings (stacking, fanout, etc.) *
* After restoration the unit(s) will be powercycled immediately. *
* Proceed with caution ! *
***********************************************************************
Proceed with factory settings? Confirm [yes/no]:yes
-- Restore status --
Unit Nvram Config
------------------------
1Success
Power-cycling the unit(s).
FTOS#
all
Enter this keyword to display boot image information for all linecards and
rpms.
linecard
Enter this keyword to display boot image information for the specified
linecard(s) on the system.