Reference Guide

44 | File Management
www.dell.com | support.dell.com
Example
Command example: restore fpga-image
Usage
Information
Reset the card using the power-cycle option after restoring the FPGA command.
Related
Commands
restore factory-defaults
Restore factory defaults.
Syntax
restore factory-defaults stack-unit {0-5 | all} {clear-all | nvram}
Parameters
Command Modes
EXEC Privilege
Command
History
Usage
Information
Restoring factory defaults deletes the existing startup configuration and all persistent settings
(stacking, fanout, etc.).
When restoring all units in a stack, all the units in the stack are placed into stand-alone mode.
FTOS#restore fpga-image linecard 4
Current FPGA information in the system:
=======================================
Card FPGA Name Current Version New Version
------------------------------------------------------------------------
LC4 48 Port 1G LCM FPGA A: 3.6 restore
***********************************************************************
* Warning - Upgrading FPGA is inherently risky and should *
* only be attempted when necessary. A failure at this upgrade may *
* cause a board RMA. Proceed with caution ! *
***********************************************************************
Restore fpga image for linecard 4 [yes/no]: yes
FPGA restore in progress. Please do NOT power off the card.
!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!
!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!
Upgrade result :
================
Linecard 4 FPGA restore successful.
reset Reset a card.
factory-defaults
Return the system to its factory default mode.
0-5
Enter this keyword to restore only the mentioned stack-unit.
all
Enter this keyword to restore all units in the stack.
clear-all
Enter this keyword to reset the NvRAM and the system startup configuration.
nvram
Enter this keyword to reset the NvRAM only.
Version 8.3.3.9 Introduced on the S60
Version 8.3.5.5 Introduced on the S55
Version 8.3.17.1 Supported on M I/O Aggregator