Reference Guide

File Management | 43
Figure 3-4. restore factory-defaults (NvRAM only, single unit in a stack) Command
Example
restore fpga-image
c
Copy the backup C-Series FPGA image to the primary FPGA image.
Syntax
restore fpga-image {rpm | linecard} number
Parameters
Defaults
None.
Command Mode
EXEC Privilege
Command
History
FTOS#restore factory-defaults stack-unit 1nvram
***********************************************************************
* Warning - Restoring factory defaults will delete the existing *
* persistent settings (stacking, fanout, etc.) *
* After restoration the unit(s) will be powercycled immediately. *
* Proceed with caution ! *
***********************************************************************
Proceed with factory settings? Confirm [yes/no]:yes
-- Restore status --
Unit Nvram Config
------------------------
1Success
Power-cycling the unit(s).
FTOS#
rpm Enter rpm to upgrade an RPM FPGA.
linecard Enter linecard to upgrade a line card FPGA.
number
Enter the line card or RPM slot number.
C-Series Line Card Range: 0-7, RPM Range: 0-1
Version 7.7.1.0
Renamed keyword
primary-fpga-flash to fpga-image.
Version 7.5.1.0 Introduced on C-Series