Reference Guide

26 | File Management
www.dell.com | support.dell.com
• show file-systems
• show linecard
• show os-version
• show running-config
• show sfm
• show startup-config
• show version
• upgrade (E-Series version)
• upgrade (C-Series version)
• upgrade (S-Series management unit)
• upgrade fpga-image (E-Series)
• upgrade fpga-image (C-Series)
• upgrade fpga-image (S55)
boot config
ce
Set the location and name of the configuration file that is loaded at system start-up (or reload) instead
of the default startup-configuration.
Syntax
boot config {remote-first | rpm0 file-url | rpm1 file-url}
To return to the default setting, enter no boot config {remote-first | rpm0 | rpm1}.
Parameters
Defaults
Not configured.
Command Modes
CONFIGURATION
Command
History
Usage
Information
To display these changes in the show bootvar command output, you must save the running
configuration to the startup configuration (copy running-config startup-config or write).
Dell Networking strongly recommends using local files for configuration (RPM0 or RPM1 flash or
slot0).
remote-first Enter the keywords remote-first to attempt to load the boot configuration files from a
remote location.
rpm0 Enter the keywords rpm0 first to specify the local boot configuration file for RPM 0.
rpm1 Enter the keywords rpm1 first to specify the local boot configuration file for RPM 1.
file-url
Enter the location information:
• For a file on the internal Flash, enter
flash:// followed by the filename.
• For a file on the external Flash, enter
slot0:// followed by the filename.
Version 7.5.1.0 Introduced on C-Series
E-Series original Command