Command Line Reference Guide

SNMP and Syslog | 987
snmp-server packetsize
c e s
Set the largest SNMP packet size permitted when the SNMP server is receiving a request or generating
a reply, use the snmp-server packetsize global configuration command.
Syntax
snmp-server packetsize byte-count
Parameters
Defaults
8
Command Modes
CONFIGURATION
Command
History
snmp-server trap-source
c e s
Configure a specific interface as the source for SNMP traffic.
Syntax
snmp-server trap-source interface
To disable sending traps out a specific interface, enter no snmp trap-source.
Parameter
Defaults
The IP address assigned to the management interface is the default.
Command Modes
CONFIGURATION
Command
History
Usage
Information
For this snmp-server trap-source command to be enabled, you must configure an IP address on the
interface and enable the interface configured as an SNMP trap source.
byte-count
Enter one of the following values 8, 16, 24 or 32. Packet sizes are 8000 bytes, 16000 bytes,
32000 bytes, and 64000 bytes.
Version 8.3.5.0 Introduced on S55
Version 7.6.1.0 Support added for S-Series
Version 7.5.1.0 Support added for C-Series
E-Series legacy command
interface
Enter the following keywords and slot/port or number information:
• For an 100/1000 Ethernet interface, enter the keyword
GigabitEthernet
followed by the slot/port information.
• For a 1-Gigabit Ethernet interface, enter the keyword
GigabitEthernet
followed by the slot/port information.
• For a Loopback interface, enter the keyword
loopback followed by a
number from 0 to 16383.
• For a SONET interface, enter the keyword
sonet followed by the slot/port
information.
• For a 10-Gigabit Ethernet interface, enter the keyword
TenGigabitEthernet followed by the slot/port information.
Version 8.3.5.0 Introduced on S55
Version 7.6.1.0 Support added for S-Series
Version 7.5.1.0 Support added for C-Series
E-Series legacy command