Command Line Reference Guide

SNMP and Syslog | 981
Parameters
Defaults
No default values or behavior
Command Modes
CONFIGURATION
Command
History
snmp-server enable traps
c e s
Enable and configure SNMP traps.
Syntax
snmp-server enable traps [notification-type] [notification-option]
To disable traps, use the no snmp-server enable traps [notification-type] [notification-option]
command.
Parameters
Defaults
Not enabled.
Command Modes
CONFIGURATION
Command
History
text
Enter an alphanumeric text string, up to 55 characters long.
Version 8.3.5.0 Introduced on S55
Version 7.6.1.0 Support added for S-Series
Version 7.5.1.0 Support added for C-Series
E-Series legacy command
notification-type
Enter the type of notification from the list below:
•
bgp—for notification of changes in BGP process
•
envmon—for Force10 Networks device notifications when an
environmental threshold is exceeded
•
snmp—for notification of the RFC 1157 traps.
•
stp - Allow Spanning Tree protocol notification (RFC 1493)
•
xstp - Allow MSTP (802.1s), RSTP (802.1w), and PVST+ state change
traps
notification-option
For the envmon notification-type, enter one of the following optional
parameters:
• fan
• supply
• temperature
For the
snmp notification-type, enter one of the following optional parameters:
• authentication
• coldstart
• linkdown
• linkup
Version 8.3.5.0 Introduced on S55
Version 7.6.1.0 Support added for S-Series; Added support for STP and xSTP notification types.
Version 7.5.1.0 Support added for C-Series
E-Series legacy command